NEC SL1100 - Page 592

• The hardware/software requirements to run PCPro :
Item Requirement
CPU Pentium® III 598 MHz (minimum)
Pentium 4 2.5 GHz (recommended)
Memory 128 MB of RAM, 256 MB (recommended)
Operating System (OS) Windows XP or Microsoft Vista
Windows 7 (32– and 64–bit)
Other Microsoft Internet Explorer 6.0 or higher
Communication Port LAN or Modem
Disk Space 35 MB for PCPro (minimum)
TCP Port TCP port 8000 must be open between the terminal and the host PC for
uploading/ downloading via LAN. PCPro/WebPro TCP port is set for
8000 at default, but can be changed via WebPro using PRG 90-38-02.
PRG 90-38-02 is not accessible from Telephone Programming or PCPro.
TCP port 5963 is required to be open if the Debug Terminal is going to
be used.
Screen Resolution 800 x 600 (minimum)
1024 x 760 (recommended)
• The hardware/software requirements to run WebPro :
Item Requirement
Browser MS Internet Explorer 6.0 (or higher)
Mozilla® Firefox® 1.0.3 (or higher)
Network IP connection to the KTS
Screen Resolution 800 x 600 (minimum)
1024 x 760 (recommended)
• You can have a maximum of four users logged into WebPro same time.
• You can have up to two phones in programming mode same time.
• You can have total of four users in programming mode at same time. This can be a any mix of
Telephone programming user and Webpro user as long as it wont exceed four users.
• Only One user can be logged into PC PRO. While user is logged into PC PRO Webpro, Telephone
programming couldn't be used.
• When programming via WebPro/PCPro, it requires you to logout before the system fully applies the
changes.
• In the System Data configuration window, you can open/close the system data by clicking the
system data you want to open/close.
• Some programs may needs the system to reset/reboot order for the system to effect the change that
been made. These Programs are: 10-12-01, 10-12-02, 10-12-03, 10-12-04, 10-13-01, 10-13-02,
10-13-03, 10-14, 10-15, 10-16-01, 10-16-02, 10-16-03, 10-16-04, 20-01-03, 47-01-01, 80-01,
80-02-01, 80-02-02, 80-02-03, 80-02-04, 80-03, 80-04, 84-03-01, 84-03-02, 84-03-06, 84-03-07,
84-03-08, 84-05-01, 84-09 and 84-10.
• When using a Card Configuration to update your system. Please disconnect after upload is done.
Then please re-start the system order for system to function properly. Until System re-start phone
will not work.
Default Settings
None
SL1100
ISSUE 2.0
1-580
PC Programming
P