NEC SL1100 - Page 605

Link Description System Data Note
BRI Indicate Icon, Name and
number of Line
PRG 10-03-01 (BRI): ISDN Line Mode
PRG 10-03-02 (BRI): Logical Port Number
PRG 14-01-01: Trunk Name
PRG 10-03-03 (BRI): Connection Type
PRG 22-04/22-05: IRG settings
PRI Indicate Icon, Name and
number of Line
PRG 10-03-01 (PRI): ISDN Line Mode
PRG 10-03-02 (PRI): Logical Port Number
PRG 14-01-01: Trunk Name
PRG 10-03-03 (PRI): CRC Multi-frame (CRC4)
PRG 22-04/22-05: IRG settings
VOIP Indicate Icon, Name and
number of Trunk
PRG 14-01-01: Trunk Name
PRG 22-04/22-05: IRG settings
PRG 10-12-09: IP Address
PRG 10-12-10: Subnet Mask
PRG 10-29-14: SIP Carrier Choice
PRG 10-40-01: IP Trunk Availability
PRG 10-40-02: Number of Ports
PRG 10-28-01: Domain Name
PRG 10-28-02: Host Name
PRG 10-28-03: Trans Port Protocol
PRG 10-28-04: User ID
PRG 10-28-05: Domain Assignment
PRG 10-29-01: Default Proxy (Outbound)
PRG 10-29-02: Default Proxy (Inbound)
PRG 10-29-03: Default Proxy IP Address
PRG 10-29-04: Default Proxy Port Number
PRG 10-29-05: Register Mode
PRG 10-29-06: Register IP Address
PRG 10-29-07: Register Port Number
LAN
(CPU)
Indicate Icon and Name PRG 10-12-01: IP Address
PRG 10-12-02: Subnet Mask
PRG 10-12-03: Default Gateway
MOH Indicate Icon and Name PRG 10-04-01: MOH Source Selection
PRG 10-04-02: MOH Tone Selection
BGM Indicate Icon and Name PRG 10-61-01: Relay Type
PRG 10-61-02: Destination Selection
PRG 15-07-01: Function Key settings
Paging Indicate Icon and Name PRG 31-04-01: External Paging Zone Group selection
PRG 31-10-01: External Speaker Name
PRG 15-07-01: Function Key settings
InMail Indicate Icon, Name and
number of InMail
PRG 47-01-17: InMail Port
PRG 11-07-01: Department Group Pilot Number
• At PRG 11-07 InMail group pilot number can be set.
T1 Indicate Icon, Name and
number of Line
PRG 14-01-01: Trunk Name
PRG 22-04/22-05: IRG settings
PRG 10-03-03 (T1): Zero Code Suppression
At Intuition Setup following two programming method is newly supported.
• IRG (Incoming Ring Group) settings.
• Function Key settings for BGM and External paging.
Detail features are described in below section.
IRG Settings
In Intuition Setup IRG Setting handles Ring Group number. When new Ring Group configuration (new
member group) is created, new Ring Group number is generated automatically.
For example, from the KSU View, click the Analog trunk figure to be set IRG setting.
ISSUE 2.0
SL1100
Features and Specifications Manual 1-593
P