To set and change the destination of the Automatic Tandem Trunk call:
1. Dial service code 735 (or the service code set for Set Destination for Automatic Trunk-to-Trunk
Transfer).
2. Dial the desired trunk number (Trunk Number: 001~084).
3. Dial the destination Number (trunk access code is not needed).
4. Dial the desired time mode (Time Mode: 1~8).
5. Press Hold key.
6. Hang up.
To disconnect the Conference, use Forced Trunk Disconnect (i.e., Press the line key or #9 plus the
trunk number + PRG 11-10-26 ).
Continue/Disconnect Codes
To use the Continue code to extend a Tandem Trunk call:
1. An external call connects to an external number either by transferring with Tandem Trunking or by
DISA caller.
2. After the programmed time (PRG 24-02-07), a warning tone is heard and the user dials the
Continue code (PRG 20-28-01) to extend the conversation.
3. After the programmed time (PRG 20-28-03), the warning tone is heard again. After the
programmed time (PRG 24-02-10), the call is disconnected.
ISSUE 2.0 SL1100
Features and Specifications Manual 1-741
T
To Next Page
Loading...
