NEC SL1100 - Page 804

5. Press Hold. You can set Name (PRG 13-04-02).
ABB 0005
-
(This display indication is for IP and Multiline Terminals.)
6. Press Hold and Enter the Transfer Mode 0 ~ 3 (PRG13-04-03).
TRF0 = Not defined
TRF1 = Internal Dial
TRF2 = IRG
TRG3 = Remote Monitor
ABB0005
TRF Mode(0-3)?0-
(This display indication is for IP and Multiline Terminals.)
7. Press Hold and Enter the Ringing Destination (13-04-04).
If you Select TRF1 ~3 following can be entered/
TRF1 (Internal Dial): Up to 36 digits
TRF2 (Incoming ring Group): 0-25
TRF3 (Remote Monitor): Dial Up to 8 digits.
If you press Exit Key you can clear the digits you entered.
ABB0005 ModeX Target
ModeX= X is Mode 1 ~ 3 (13-04-03)
(This display indication is for IP and Multiline Terminals.)
8. Press Hold and you enter the Incoming Ring Pattern (13-04-05).
0 ~ 9 can be entered and 0 ~ 9 are followings:
0 = Normal pattern
1-4 = Tone pattern (1-4)
5-9 = Scale pattern (1-5)
ABB0005 ModeX
Ring(0-9)?1-
ModeX = X is Mode 1 ~ 3 (PRG 13-04-03)
(This display indication is for IP and Multiline Terminals.)
9. Enter the VRS Incoming Message Number: 000 ~ 100 (13-04-07).
ABB0005 ModeX VRS
001
ModeX = X is Mode 1 ~ 3 (PRG 13-04-03)
(This display indication is for IP and Multiline Terminals.)
SL1100
ISSUE 2.0
1-792
Voice/Melody Ringing by VM
V