NEC SL1100 - Table 2-4 Function Key Codes by Feature

For this fea-
ture...
Dial this Service Code...
1
When you ... Also see
Function
Key...
Note
1
Except where indicated, dial Service Code from intercom dial tone (e.g., press idle Speaker
key first).
Voice Response
System (VRS)
**
+ ringing ext. Pick up a call ringing another exten-
sion for Directed Call Pickup or VRS
Park and Page.
-
616 + 7 + Record message + # + Con-
dition (2, 4,6 or 7) + Destination +
Type (2 or 3) or 616 + 7 + 3 to cancel
Record, listen to or erase a Person-
al Greeting or Park and Page.
-
4 (On-Hook) Listen to the General Message. -
6 (On-Hook) Check an extension number. -
8 (On-Hook) Listen for the time. -
611 Use SLT to listen to the General
Message.
-
612 + 3 to erase, 5 to listen or 7 to re-
cord
Record, listen to or erase the Gen-
eral Message.
-
616 + 3 to erase, 5 to listen or 7 to re-
cord
Record, listen to or erase a VRS
Message.
-
750 Camp On to an extension when call-
ing into the system through the
VRS.
-
782 Transfer a call to the VRS. This can
be used also to route ANI/DNIS to
the VRS.
-
Volume Control 729 Check or change ring volume. -
Common Cancel-
ing Service Code
*
9 Use Common Canceling Service
Code.
-
Function Key Codes by Feature
Table 2-4 Function Key Codes by Feature
To program a key, press Speaker key, dial 751 (for 3-digit code) or 752 (for 2-digit codes), press the key
and enter the code (e.g., 48 for Voice Over).
For this
feature...
Use this key... When you ... Key Lamp Status Also See Srvc
Code
Note
Speed Dial-
ing
Code: 27
Operation: Press key +
bin + Line or Hold key
Dial a stored System
Speed Dialing num-
ber.
None #2 + bin
Code: 28
Operation: Press key +
bin + Line or Hold key
Dial a stored Group
Speed Dialing num-
ber.
None #4 + bin
Account
Codes
Code: 50
Operation: Press key +
Dial Account Code
Enter Account Codes. None
*
+ Enter Account
Code +
*
ISSUE 2.0 SL1100
Features and Specifications Manual 2-15