NEC SL1100 - Page 187

NEC SL1100 Issue 6.0
Networking Manual 9 - 53
15-05-45
IP Telephone
Terminal Basic
Data Setup – NAT
Plug and Play
Effective when Program 10-46-14
is set to NAT Mode. Select sending
RTP port number to remote router,
use from negotiation result (0) or
received RTP packet (1).
0 = Off
1 = On
Default is 0
X
84-10-XX ToS Setup
Assignments deal with setting of
the Layer 3 IP Header ToS field as
it leaves the VoIPDB unit.
Specify the protocol to assign the
ToS field for, and select the
populated field to conform to either
IP Precedence or Differentiated
Services.
When setting IP Precedence,
assign Priority, Delay, Throughput,
and Reliability in Programs
84-10-01/02/03/04/05.
When setting DiffServ, only assign
the DSCP in Program 84-10-07.
Protocol Type
0 = Networking
2 = RTP/RTCP
3 = SIP
4 = DR700
5 = SIP Trunk
X
84-22-01
DR700 Multiline
Logon Information
Setup – User ID
User ID for Manual or Auto
registration (Program 10-46-01).
Assign up to 32 Alpha/
Numeric Characters
Default is No Setting
X
84-22-02
DR700 Multiline
Logon Information
Setup – Password
Password for Manual or Auto
registration (Program 10-46-01).
Assign up to 16 Alpha/
Numeric Characters
Default is No Setting
X
84-22-03
DR700 Multiline
Logon Information
Setup – User ID
Omission
When set to manual login mode,
the user ID is omitted from the
display during entry by the user.
0 = Off
1 = On
Default is 0
X
84-22-04
DR700 Multiline
Logon Information
Setup – Log Off
Allow the ability to log off from the
IP terminal when using manual
registration mode.
0 = Off
1 = On
Default is 1
X
84-22-05
DR700 Multiline
Logon Information
Setup – Nickname
Assign up to 32 Alpha/Numeric
characters.
Assign up to 32 Alpha/
Numeric Characters
Default is No Setting
X
84-23-01
DR700 Multiline
Basic Information
Setup –
Registration Expire
Timer
At half the value of this timer the IP
terminal sends another registration
message to the CPU.
Range: 60~65535
Sec.
Default is 180
X
Program
Number
Program Name Description/Comments Assigned Data 1 2 3