NEC SL1100 - Page 226

Issue 6.0 NEC SL1100
10 - 14 IP Single Line Telephone
10-26-03
IP System
Operation Setup –
SIP Peer to Peer
Mode
Enable or disable Peer-to-
Peer mode for SIP
phones with Version 4.0
or higher software. When
PRG 10-33-05 NAT mode
is set to 1 (Enable), P2P
mode for SIP phones
always set to Off
automatically regardless
of this program setting.
0 = No (Disable)
1 = Yes (Enable)
default is 0
X
10-33-02
SIP Registrar/Proxy
Information Basic
Setup –
Authentication
Mode
When connecting STD
SIP Terminal via NAT, this
option must be enabled to
prohibit illegal SIP phone
registration.
0 = No (Disable)
1 = Yes (Enable)
default is 0 X
10-33-05
SIP Registrar/Proxy
Information Basic
Setup NAT Mode
When system controls
remote SIP phone via
NAT router, set this
program to 1 = Enable.
0 = No (Disable)
1 = Yes (Enable)
default is 0
X
10-37-01
UPnP Setup –
UPnP Mode
Default Gateway (WAN),
PRG 10-12-07 can be set
automatically when this
program is set to 1 =
Enable. (Version 4.0
added)
0 = No (Disable)
1 = Yes (Enable)
default is 0
X
10-58-01
Network Address –
Network Address
If there are other
networks connected to
this system that are not to
be routed through NAPT
translations, then these
networks must be
identified in PRG 10-58.
Use this PRG to assign
the individual IP Address
(e.g. 192.168.1.100) or
assign the whole network
address (e.g.
192.168.1.0).
Assign a valid IP Address or
assign a valid Network
Address.
default is 0.0.0.0
X
Program
Number
Program Name
Description/
Comments
Assigned Data 1 2 3