NEC SL1100 - Remote Upgrade Function by Webpro; Figure A-16 Remote Firmware Update Screen

NEC SL1100 Issue 3.01
PC Programming Manual A - 17
___________________________________________________________________________________
___________________________________________________________________________________
6.3 Remote Upgrade Function by WebPro
This function is available with Version 4.0 or higher system software.
1. The user level which performs the Remote Update is as follows:
1 = MF (Manufacturer Level)
2 = IN (Installer Level)
2. You can choose “Immediately” or “At the time” as installation timing.
3. Immediately means the Update will be performed immediately after
uploading is complete.
4. At the time means the Update will perform at a preset date and time.
5. When the start button is pressed the upload process will begin even if “At
the time” is set.
Below is an example of remote firmware update.
Figure A-16 Remote Firmware Update Screen
Select Firmware
Update