NEC SL1100 - Page 522

Item
No.
Item Input Data Description Default Related
Program
39 G.726 Silence
Compression
Mode
0 = Disable
1 = Enable
Select whether to compress silence
with G.726. When there is silence,
the RTP packet is not sent.
0
40 G.726 Jitter Buf-
fer - Minimum
0 ~ 255 ms Set the minimum value of the Jitter
Buffer of G.726 is set. Jitter is the
variation in the time between pack-
ets arriving and the buffer allows this
variation to be absorbed.
30
41 G.726 Jitter Buf-
fer - Standard
0 ~ 255 ms Set the average G.726 Jitter Buffer. 60
42 G.726 Jitter Buf-
fer - Maximum
0 ~ 255 ms Set the maximum G.726 Jitter Buf-
fer.
120
43 iLBC Audio
Frame
2 = 20 ms
3 = 30 ms
4 = 40 ms
Maximum number of iLBC Audio
Frames. iLBC assumes the frame of
10 ms is a unit.
3
45 iLBC Jitter Buffer
- Minimum
0 ~ 255 ms Set the minimum value of the Jitter
Buffer of iLBC is set. Jitter is the var-
iation in the time between packets
arriving and the buffer allows this
variation to be absorbed.
30
46 iLBC Jitter Buffer
- Standard
0 ~ 255 ms Set the average iLBC Jitter Buffer. 60
47 iLBC Jitter Buffer
- Maximum
0 ~ 255 ms Set the maximum iLBC Jitter Buffer. 120
48 ILBC Payload
Number
96 ~ 127 The payload number of iLBC is set.
However, the same number as Item
31 cannot be set.
98
49 RTP Filter 0 = Disable
1 = Enable
0
50 Fax Relay mode 0 = Disable
1 = T.38 (V4.0
Changed)
2 = Path Through (V4.0
Added)
Set the FAX Relay Mode.
2:Path Through Mode has more
detail setting at PRG 84-32
(V4.0 Added)
0
51 T.38 Protocol
mode
0 = R/U (V1.5
Changed)
1 = U/R (V1.5
Changed)
2 = RTP (V1.5
Changed)
3 = UDPTL (V1.5
Changed)
1
52 Fax Max Rate 1 = V.27ter, 4800 bps
3 = V.29, 9600 bps
5 = V.17, 14400 bps
5
56 Low Speed Data
Redundancy
0 ~ 2 0
57 High Speed Data
Redundancy
0 ~ 2 0
58 TCF Handling 0 = Local
1 = Network
1
61 T.38 RTP Format
Payload Number
96 ~ 127 100
62 DTMF Level
mode
0 = VoIPDB Unit
1 = Main Soft
0
63 DTMF Level High 1 = - 33 dBm
:
28 = - 6 dBm
28
SL1100 ISSUE 6.0
2-502 Program 84 : Hardware Setup for VoIPDB
Program
84