NEC SL2100 - Page 172

4. Press the STORE softkey. The display shows:
##: xxxxxxxxxxxxx
mm-dd hh:mm
STA Abb
## = List Number
xx = Caller ID number
mm-dd hh:mm = incoming date and time
STA = Store in Station Speed Dial bin.
Abb = Store in System Speed Dial bin.
5. Press the STA softkey. The display shows:
Store to Personal ABB
ENTER BIN
6. Press the One-Touch key in which the number is to be stored or dial 1~9, 0. If you press Hold
key, the next available One-Touch key will be used. The display shows:
Store to Personal ABB
Insert 9?(Y:1,N:0)
If all One-Touch keys are used, the display shows “TABLE IS FULL”.
7. Press 1 (Yes) to add 9 or 0 for Trunk Access Code. The display shows:
- OR -
Press 0 (No) for not adding Trunk Access Code. The display shows:
SPD 01
9XXXXXXXXXX
8. Press Hold key. The display shows:
SPD 01
-
9. Enter the name to be associated with the stored number. Refer to Table 1-5 Keys for Entering
Names on page 1-155.
10. Press Hold key. The display shows:
SPD Program
11. Press Speaker key.
The telephone returns to an idle condition.
Temporary Memory
An unanswered call causes the Call History key (PRG 15-07 or SC 751: 08) to flash, indicating a new
call was placed in the temporary memory. If enabled in programming, the telephone display shows
CHECK LIST.
SL2100
ISSUE 1.0
1-158
Caller ID
C