• When defining trunks as DID or DID Mode in PRG 22-02-01, DID translation (PRG 22-11 or PRG
22-17) must be used, even if the incoming digits match the extension number.
• When using DID Call by T
ime Schedule and breaking out the Time Patterns, set the start time to
00:00 and end time to 00:00 for this feature to operate correctly. Refer to DID Call by Time
Schedule on page 1-249 for more details.
• DID Call by Time Schedule Priority is given to the pattern that is set manually. However, when a
time pattern changes with the time schedules set in PRG 22-17, the pattern applied by the Manual
change is canceled and the Time Pattern is given priority.
• When Transfer Operation Mode is set to busy, call queuing must be turned off for it to work.
Default Settings
Disabled
Related Features
Central Office Calls, Answering
Direct Inward Line (DIL)
Direct Inward System Access (DISA)
Off-Hook Signaling
Paging, External
Programmable Function Keys
Station Message Detail Recording
Transfer
Guide to Feature Programming
The programs listed below indicate the most commonly used programs required for this feature. The
programs are listed in the order that the installer should follow
. Refer to the PCPro wizards for further
detailed programming.
•
When a
* is listed next to the Program Number it indicates a program that
MUST be set (from a
default state) for this feature to be enabled.
DID Line Service
Program
No.
Program Name Input Data Default
14-05-01 * Trunk Group - Trunk Group Number Trunk Port 1 ~ 128 = Priority 1 ~
128
0 ~ 50 = Trunk Group
1
ISSUE 1.0 SL2100
Features and Specifications Manual 1-253
D
To Next Page
Loading...
