NEC SL2100 - Page 268

Program
No.
Program Name Input Data Default
22-02-01 * Incoming Call Trunk Setup - Trunk Service Type 0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = Tie Line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID (DDI) Mode Switching
0
22-09-01 DID Basic Data Setup - Dial-In Receive digit 1 ~ 8 2
22-09-02 DID Basic Data Setup - Received Vacant Number
Operation
0 = Disconnect (call denied)
1 = T
ransfer (call routed to PRG
22-12)
0
22-13-01 DID Trunk Group to Translation Table Assign-
ment - Translation Table
0 ~ 20
(0 = No Setting)
1
22-10-01 DID Translation Table Setup 0 ~ 1000
(0 = No Setting)
1st:
1 Start - 1, End - 200
2 Start - 201, End - 400
3 Start - 401, End - 600
4 Start - 601, End - 800
5 ~ 20 Start - 0, End - 0
2nd:
1 ~ 20 Start - 0, End - 0
22-11-01 * DID Translation Table - Received Number Maximum of 8 digits (0 ~ 9,
*
, #) Refer to the Program-
ming Manual.
22-11-02 * DID Translation Table - Target Number Maximum 36 digits
(0 ~ 9,
*
, #)
Refer to the Program-
ming Manual.
22-11-03 DID Translation Table - DID Name Maximum 12 characters No Setting
22-11-04 DID Translation Table - Transfer Operation Mode 0 = No Transfer
1 = Busy
2 = No Answer
3 = Busy/No Answer
0
22-11-05 DID Translation Table - Transfer Destination
Number 1
0 = No setting
01 ~ 50 = Incoming Ring Group
102 = VM
201 ~ 250 = Department Group
400 = VRS
401 = DISA
501 ~ 599 = DISA/VRS Message
1000 ~ 1999 = Common ABB Di-
al (000 ~ 999)
0
22-11-06 DID Translation Table - Transfer Destination
Number 2
0 = No setting
01 ~ 50 = Incoming Ring Group
102 = VM
103 = Centralized VM
201 ~ 250 = Department Group
400 = VRS
401 = DISA
501 ~ 599 = DISA/VRS Message
1000 ~ 1999 = Common ABB Di-
al (000 ~ 999)
0
22-11-11 DID Translation Table - Incoming Ring Group
Transfer
0 = Disable (Calls will not be
routed to PRG 22-12.)
1 = Enable (Calls will be routed
to PRG 22-12.)
0
22-12-01 DID Intercept Ring Group - Incoming Ring Group
Number
0 = No setting
01 ~ 50 = Incoming Ring group
102 = VM
103 = Centralized VM
1
22-01-06 System Options for Incoming Calls -
DID Ring-
No-Answer Time
0 ~ 64800 seconds 20
SL2100 ISSUE 1.0
1-254
Direct Inward Dialing (DID)
D