• Detail programming of Distinctive Ringing, Tones and Flash Patterns for the multiline terminal, refer
below chart.
PRG22-03-01
0-3, 9-12 =
Tone Pattern
PRG15-02-02 PRG22-03-01
4-8 = Melody
1-3 = High, Middle, Low
4-8 = Melody
0-3, 9-12 =
Tone Pattern
4-8 = Melody4-8 = Melody
1-3 = High, Middle, Low
PRG15-28-01
0 = Trunk Incoming
Melody 1-5 set
in PRG15-28
Melody 1-5 set
in PRG22-03
Tone Pattern 1-8
High-Low (15-02)
Melody 1-5 set
in PRG22-03
Tone Pattern 1-8
High-Low (15-28)
Melody 1-5 set
in PRG15-02
Figure 1-12 <IP7WW-12/24TXH-B1 TEL and IP7[ ]-8IPLD-C1 TEL>
Tone pattern 5 to 8 are available.
• The following voice mail features require system tones be changed in PRG 80-01-02 to work. Refer
to the Programming section of the InMail feature for details.
- Call Holding
- Busy Greeting
- Call Screening
- Await Answer Transfer
• When a ring group call rings a Single Line Station, the BLF indication shows busy.
• The priority of the Large LED is as follows:
1. CO Call Ringing
2. Message Waiting Received
3. VM Message Waiting
4. Message Waiting Set
• PRG 15-08 is only effective for Virtual Extensions appearing on a station when the station is set for
patterns 1~3 in PRG 15-02-02. When PRG 15-02-02 for the station is set to patterns 4~8, PRG
15-08 for Virtual Extensions is not used.
Default Settings
Enabled
System Availability
Terminals
All Multiline Terminals
ISSUE 1.0
SL2100
Features and Specifications Manual 1-281
D
To Next Page
Loading...
