Guide to Feature Programming
Program
No.
Program Name Input Data Default
15-07-01 Programmable Function Keys - Refer to the program-
ming manual for the
default values and for
all other available op-
tions in this command.
20-02-05 System Options for Multiline Telephones - Head-
set Busy Mode
0 = No (Disable)
1 = Yes (Enable)
0
20-02-12 System Options for Multiline Telephones -
Forced Intercom Ring (ICM Call Type)
0 = Disable (Voice)
1 = Enable (Signal)
1
20-09-07 Class of Service Options (Incoming Call Service)
- Call Queuing
0 = Off (Calls are not queued.)
1 = On (Calls are queued.)
COS 01 ~ 15 = 0
20-13-06 Class of Service Options (Supplementary Serv-
ice) - Automatic Off-Hook Signaling (Automatic
Override)
0 = Off (manually)
1 = On (automatically)
COS 01 ~ 15 = 1
Operation
To enable the headset:
1. Plug in the headset into the headset jack on the bottom of the telephone.
2. Program a Headset key (PRG 15-07 or SC 751: 05).
You hear a confirmation beep.
To use the headset:
The Headset key lights when on a call. To disconnect, press the Headset key again.
You can still use the handset for calls or respond to voice-announced Intercom calls with the headset
plugged in. The headset only activates when the Headset key is pressed.
1. Answer a ringing call by pressing the Headset key.
- OR -
2. Press the Headset key and then a line key or press Speaker key then 0 to make a outgoing call.
- OR -
3. Press the Headset key to get intercom dial tone.
- OR -
4. If on a call, press the Headset key to hang up.
ISSUE 1.0
SL2100
Features and Specifications Manual 1-341
H
To Next Page
Loading...
