NEC SL2100 - Page 520

Program
No.
Program Name Input Data Default
24-09-04 Call Forward Split Settings -
CO Call Forwarding Busy Destination
Maximum of 36 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer Supervision
- ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
24-09-05 Call Forward Split Settings -
Intercom Call Forwarding Busy Destination
Maximum of 36 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer Supervision
- ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
80-01 Service Tone Setup - Lockout Tone (No.16) Refer to Programming
Manual.
NAT Mode for Standard SIP terminal
Program
No.
Program Name Input Data Default
10-12-03 CPU Network Setup - Default Gateway 0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0
10-12-07 CPU Network Setup - NAPT Router IP Ad-
dress(Default Gateway [WAN])
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0
10-26-03 IP System Operation Setup - SIP Peer to Peer
Mode
0 = Off
1 = On
1
10-33-02 SIP Registrar/Proxy Information Basic Setup -
Authentication Mode
0 = Disable
1 = Enable
1
10-33-05 SIP Registrar/Proxy Information Basic Setup -
NAT Mode
0 = Disable
1 = Enable
0
10-37-01 UPnP Setup - UPnP Mode 0 = Disable
1 = Enable
0
10-58-01 Network Address - Network Address 0.0.0.0 ~ 126.255.255.254 |
128.0.0.1 ~ 191.254.255.254 |
192.0.0.1 ~ 223.255.255.254
0.0.0.0
SL2100 ISSUE 1.0
1-506
IP Single Line Terminal (SIP)
I