DID Services for either ISDN - BRI or PRI:
Program
No.
Program Name Input Data Default
22-02-01 Incoming Call Trunk Setup - Trunk Service Type 0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = Tie Line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID (DDI) Mode Switching
0
22-09-01 DID Basic Data Setup - Dial-In Receive digit 1 ~ 8 2
22-11-01 DID Translation Table - Received Number Maximum eight digits
(0 ~ 9,
, #, @)
Refer to Programming
Manual.
22-11-02 DID Translation Table - Target Number Maximum 36 digits
(0 ~ 9,
, #, @)
Refer to Programming
Manual.
Calling Party Number Presentation for either ISDN - BRI or PRI:
Program
No.
Program Name Input Data Default
10-03-05 ETU Setup (PRTA PKG Setup) - CLIP Information
Announcement
0 = No
1 = Yes
1
15-01-04 Basic Extension Data Setup - ISDN Caller ID 0 = Disabled (CPN is NOT sent.)
1 = Enabled (CPN is sent.)
1
20-06-01 Class of Service for Extensions - Class of Serv-
ice for Extensions
1 ~ 15 Extension 101 is Class
15 and other Extension
are Class 1
20-08-13 Class of Service Options (Outgoing Call Service)
- Set Calling Party Number
0 = Off (when set to Off the sys-
tem will not send any outbound
calling party information.)
1 = On (when set to ON the sys-
tem will send calling party infor-
mation for the station or trunk.)
COS 01 ~ 15 = 1
21-12-01 ISDN Calling Party Number Setup for Trunks -
Calling Party Number Data
Maximum of 16 digits (0 ~ 9,
,
#)
Most Telco's will only accept 10
digits.
No Setting
21-13-01 ISDN Calling Party Number Setup for Extensions
- Calling Party Number Data
Maximum of 16 digits (0 ~ 9,
,
#)
Most Telco's will only accept 10
digits.
No Setting
ISDN - PRI Network Specific Assignment:
Program
No.
Program Name Input Data Default
26-02-07 Dial Analysis Table for ARS/LCR - Network
Specified Parameter Table
0 ~ 16 0
SL2100 ISSUE 1.0
1-540
ISDN Compatibility
I
To Next Page
Loading...
