NEC SL2100 - Page 567

1. At the Multiline Terminal, press Speaker key or lift the handset (optional).
The system automatically selects a trunk from the same group as your original call.
2. Press the Redial key.
- OR -
At the Single Line Terminal, lift the handset.
3. Dial #5.
The system automatically selects a trunk from the same group as your original call and dials the last
number dialed.
To check the number saved for Last Number Redial (When set PRG 15-02-60:0):
1. Press the Redial or Left Cursor key once.
The stored number displays for six seconds. The stored number dials out if you:
• Lift the handset,
• Press an idle line key,
- or -
• Press Speaker key
2. Press Exit key.
To erase the stored number:
1. At the Multiline Terminal, press Speaker key or lift handset.
- OR -
At the Single Line Terminal, lift the handset.
2. To Clear all the stored number, dial 776.
To redial the last number, you can do the following: (When set PRG 15-02-60:1 or 2):
1. Press the Right Cursor key once and the Up or Down Cursor key to find number.
2. After the number been selected you can make a call by following ways:
• Press Speaker key.
• Lift the Handset.
• Press the Right Cursor key once.
• Press the Enter Cursor key.
The system automatically selects a trunk from the same group as your original call and dials the last
number dialed.
- OR -
1. At the Multiline Terminal, press Speaker key or lift the handset (optional).
The system automatically selects a trunk from the same group as your original call.
2. Dial #5.
The system automatically selects a trunk from the same group as your original call and dials the last
number dialed.
ISSUE 1.0 SL2100
Features and Specifications Manual 1-553
L