Guide to Feature Programming
Program
No.
Program Name Input Data Default
14-01-23 Basic Trunk Data Setup - Least Cost Routing 0 = LCR Off
1 = LCR On
2 = LCR On (Cost Center Code
only)
0
26-01-04 Automatic Route Selection (ARS/F-Route) Serv-
ice - LCR Mode Option
0 = UK style
1 = Not UK style
1
26-02-01 Dial Analysis Table for ARS/LCR -
Dial
Maximum of 16 digits (0 ~ 9,
,
#, @)
No Setting
26-02-06 Dial Analysis Table for ARS/LCR -
LCR Carrier Table
0 ~ 25 0
26-05-01 LCR Carrier Table - Delete Digits 0 - 16 0
26-05-02 LCR Carrier Table - Access Code Maximum 16 digits
(0 ~ 9,
, #, P, @)
P = Pause
@ = Change to DTMF or wait for
Connect
No Setting
26-05-03 LCR Carrier Table - Authorization Code Table 0 ~ 10
(0 = No Authorization code)
0
26-05-04 LCR Carrier Table - Cost Center Code 0 = Not Used
1 = Used
0
26-06-01 LCR Authorization Code Table - Authorization
Code
Up to 10 digits No Setting
26-07-01 LCR Cost Center Code Table - Cost Center Code Up to 8 digits Extension Number
26-08-01 LCR Manual Override Access Code Table - Man-
ual Override Code
Maximum 4 digits
(0 ~ 9,
, #)
No Setting
26-09-01 LCR Manual Override Exemption Table - Exemp-
tion Number
Maximum 4 digits
(0 ~ 9,
, #)
Do not include the Access Code.
Table 1 = 000
Table 2 ~ 25 = No Set-
ting
Note 1) Change to DTMF Operation
In PRG 26-05-02 the @ symbol will have different operation for Analogue trunks or ISDN trunks.
Analogue Trunks
At the point in the dialled digits where the @ appears the SL2100 will revert to DTMF dialling. This is only required when the
analogue trunk is set the Loop Disconnect dialling in PRG 14-02-01.
ISDN Trunks
At the point in the dialled digits where the @ appears the SL2100 will stop dialling and wait for the CONNECT from the indirect
carrier. The SL2100 will then continue to dial DTMF in the B-channel. The DTMF digits will be received by the indirect carrier
for routing.
This is only required for indirect carriers that have a two stage setup process where the Access code is dialled in the D-chan-
nel to the direct carrier and all other digits are dialled as DTMF in the B-channel to the indirect carrier.
Note 2) Order of LCR Routing Digits
When a user dials a number that is routed by LCR the individual LCR elements will be dialled to line as shown below.
<Access Code> <Authorisation Code> <CCC> <Delete leading digits> <Dialled digits>
SL2100 ISSUE 1.0
1-556
LCR-Least Cost Routing
L
To Next Page
Loading...
