Do Not Disturb (DND)
Line Preference
Prime Line Selection
Programmable Function Keys
Single Line Terminals
Toll Restriction
Transfer
InMail
Guide to Feature Programming
Program
No.
Program Name Input Data Default
14-01-09 Basic Trunk Data Setup - Private Line 0 = Disable Private Line (Normal)
1 = Enable Private Line (Private
Line)
0
14-07-01 Trunk Access Map Setup - Trunk Port Number 0 = No access
1 = Outgoing access only
2 = Incoming access only
3 = Access only when trunk on
Hold
4 = Outgoing access and access
when trunk on Hold
5 = Incoming and access when
trunk on Hold
6 = Incoming and outgoing ac-
cess
7 = Full access
Access Map 1 ~ 128 =
Trunk Ports 1 ~ 128 as-
signed with option 7 ac-
cess (incoming and
outgoing access and
access when trunk is
on Hold).
15-06-01 Trunk Access Map for Extensions - Trunk Ac-
cess Map Number
001 ~ 128 1
15-07-01 Programmable Function Keys - Refer to the program-
ming manual for the
default values and for
all other available op-
tions in this command.
21-02-01 Trunk Group Routing for Extensions - Route Ta-
ble Number
0 ~ 50
0 = No Setting (Calls will not
route.)
1
22-02-01 Incoming Call Trunk Setup - Trunk Service Type 0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = Tie Line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID (DDI) Mode Switching
0
22-04-01 Incoming Extension Ring Group Assignment -
Extension Number
Maximum eight Digits Group01 has 101, 102,
103, 104, 105, 106,
107, and 108 (First 8
ports ringing)
ISSUE 1.0 SL2100
Features and Specifications Manual 1-709
P
To Next Page
Loading...
