NEC SL2100 - Page 743

Night Service
Programmable Function Keys
Guide to Feature Programming
The programs listed below indicate the most commonly used programs required for this feature. The
programs are listed in the order that the installer should follow. Refer to the PCPro wizards for further
detailed programming.
• When a * is listed next to the Program Number it indicates a program that MUST be set (from a
default state) for this feature to be enabled.
Analog Trunk Ring Group
Program
No.
Program Name Input Data Default
22-04-01 * Incoming Extension Ring Group Assignment -
Extension Number
Maximum eight Digits Group01 has 101, 102,
103, 104, 105, 106,
107, and 108 (First 8
ports ringing)
22-05-01 * Incoming Trunk Ring Group Assignment - In-
coming Group Number
0 = No Setting
01 ~ 50 = Incoming Group
102 = VMI
103 = Centralized VM
1
22-02-01 * Incoming Call Trunk Setup - Trunk Service Type 0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = Tie Line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID (DDI) Mode Switching
0
11-15-09 Service Code Setup, Administrative (for Special
Access) - Transfer to Incoming Ring Group
0~9,
*
, # Maximum of 8 digit No Setting
22-01-04 System Options for Incoming Calls - DIL No An-
swer Recall Time
0 ~ 64800 seconds
0 = No Overflow
0
22-08-01 DIL/IRG No Answer Destination - Incoming Ring
Group Number
0 = No Setting
01 ~ 50 = Incoming Group
102 = VMI
103 = Centralized VM
Group01 has 101, 102,
103, 104, 105, 106,
107, and 108 (First 8
ports ringing)
20-13-49 Class of Service Options (Supplementary Serv-
ice) - BLF Indication on CO Incoming State
0 = Off (Disabled)
1 = On (Enabled)
COS 01 ~ 15 = 0
DID calls to a Ring Group
Program
No.
Program Name Input Data Default
22-04-01 * Incoming Extension Ring Group Assignment -
Extension Number
Maximum eight Digits Group01 has 101, 102,
103, 104, 105, 106,
107, and 108 (First 8
ports ringing)
ISSUE 1.0 SL2100
Features and Specifications Manual 1-729
R