Program
No.
Program Name Input Data Default
14-06-01 * Trunk Group Routing - Trunk Group 0 = Not Set
001 ~ 050 = Trunk group No.
1001 ~ 1050 = 1000 + Route Ta-
ble No.
1
15-06-01 Trunk Access Map for Extensions - Trunk Ac-
cess Map Number
001 ~ 128 1
23-03-01 Universal Answer/Auto Answer - Route Table
Number
0 ~ 50 0
25-10-01 Trunk Group Routing for DISA - Route Table
Number
0 ~ 50
(0 = No Setting)
1
25-12-01 Alternate Trunk Group Routing for DISA - Route
Table Number
0 ~ 50
(0 = No Setting)
1
34-03-01 Trunk Group Routing for E&M Tie Lines - Route
Table Number
00 ~ 50
(0 = No setting)
1
14-07-01 Trunk Access Map Setup - Trunk Port Number 0 = No access
1 = Outgoing access only
2 = Incoming access only
3 = Access only when trunk on
Hold
4 = Outgoing access and access
when trunk on Hold
5 = Incoming and access when
trunk on Hold
6 = Incoming and outgoing ac-
cess
7 = Full access
Access Map 1~128 =
Trunk Ports 1~128 as-
signed with option 7 ac-
cess (incoming and
outgoing access and
access when trunk is
on Hold).
15-07-01 Programmable Function Keys Line Key 1 ~ 32
0 ~ 99, #00 ~ #99 (Normal Func-
tion Code 751 by default)
*00 ~ *99 (Appearance Function
Code) (Service Code752 by de-
fault)
Refer to the program-
ming manual for the
default values and for
all other available op-
tions in this command.
Operation
To place a call using Trunk Group Routing
1. At the Multiline Terminal, press Speaker key.
- OR -
At Single Line Terminal, lift the handset.
2. Dial 0 .
3. Dial number.
- OR -
1. At the Multiline Terminal, press the Trunk Group Routing key (PRG 15-07 or SC 752:
05).
2. Dial the number.
ISSUE 1.0
SL2100
Features and Specifications Manual 1-845
T
To Next Page
Loading...
