Guide to Feature Programming
Program
No.
Program Name Input Data Default
10-19-01 VoIPDB DSP Resource Selection - VoIPDB DSP
Resource Selection
0 = Common use for both IP ex-
tensions and trunks
1 = Use for IP extensions
2 = Use for SIP trunks
5 = Blocked
6 = Common without unicast
paging
7 = Multicast paging
8 = Unicast paging
Resource 1 ~ 128 = 0
10-46-11 DT800/DT700 Server Information Setup - Multi-
cast IP Address
224.0.0.0 ~ 239.255.255.255 224.0.0.10
10-46-12 DT800/DT700 Server Information Setup - Multi-
cast Port
0 ~ 65535 30000
11-12-19 Service Code Setup (for Service Access) - Inter-
nal Group Paging
0~9,
, # Maximum of 8 digit 701
15-05-38 IP Telephone Terminal Basic Data Setup - Paging
Protocol Mode
0 = Multicast
1 = Unicast
2 = Auto
0
15-07-01 Programmable Function Keys - Refer to the program-
ming manual for the
default values and for
all other available op-
tions in this command.
20-06-01 Class of Service for Extensions - Class of Serv-
ice for Extensions
1 ~ 15 Extension 101 is Class
15 and other Extension
are Class 1
20-13-29 Class of Service Options (Supplementary Serv-
ice) - Paging Display
0 = Off
1 = On
COS 01 ~ 15 = 1
31-01-01 System Options for Internal/External Paging - All
Call Paging Zone Name
Up to 12 Characters Group all
31-01-02 System Options for Internal/External Paging -
Page Announcement Duration
0 ~ 64800 seconds 1200 seconds
31-02-01 Internal Paging Group Assignment - Internal
Paging Group Number
0 ~ 50
(0 = No setting)
All stations = 1
31-02-02 Internal Paging Group Assignment - Internal All
Call Paging Receiving
0 = Off
1 = On
1
31-03-01 Internal Paging Group Settings - Internal Paging
Group Name
Up to 12 Characters Refer to the Program-
ming Manual for the
default values.
31-07-01 Combined Paging Assignments - Internal Paging
Group Number
0 ~ 50 (0 = All Internal Paging) 1
SL2100 ISSUE 1.0
1-854
Unicast/Multicast Paging Mode
U
To Next Page
Loading...
