Dial this Service
Code. . .
1
When you . . . For this feature. . . Also see
Function
Key. . .
Note
1
Except where indicated, dial Service Code from Intercom dial tone (e.g., press idle Speaker key first).
#3 Flash a trunk from an Single
Line Terminal.
Flash -
#4 + bin Dial a group Speed Dialing num-
ber.
Speed Dialing 28
#5 Use Last Number Redial. Last Number Redial -
#6 + orbit (01 ~ 64) Park a call in a system Park orbit
(1 ~ 8, 01 ~ 32 or 01 ~ 64).
Park
04 + orbit (1 ~
64)
#7 Use Personal Speed dialing. Speed Dialing -
#8 Set up an Unsupervised Confer-
ence.
Tandem Trunking (Unsuper-
vised Conference)
-
#9 + 001 ~ 128
#0 + 001 ~ 128
Place a call over a specific trunk. Central Office Calls, Placing
01 + trunk
(001 ~ 128)
0 (Off-Hook) Leave a Message Waiting at a
co-worker’s busy or unanswered
extension.
Message Waiting 35
1 (Off-Hook) Change the signaling mode of
your outgoing Intercom call.
Handsfree Answerback/Forced
Intercom Ringing
-
4 (On-Hook) Listen to the General Message. Voice Response System (VRS) -
6 (On-Hook) Check an extension number. Voice Response System (VRS) -
8 (On-Hook) Listen for the time. Voice Response System (VRS) -
9 Place a call using ARS or Trunk
Group Routing.
Automatic Route Selection
Trunk Group Routing
02
600 + code + 0 Use Dial Block. Toll Restriction, Dial Block -
601 + code + 0 Aa a supervisor use Dial Block. Toll Restriction, Dial Block -
602 + Group number
(01 ~ 50)
Set Automatic Transfer Setup for
each extension group.
Transfer -
603 + Group number
(01 ~ 50)
Cancel Automatic Transfer Set-
up.
Transfer -
604 + Group number
(01 ~ 50) + mode +
extension
Set the destination for Automatic
Transfer Setup for each exten-
sion group.
Transfer -
605 + Group number
(01 ~ 50)
Set Delayed Transfer for each
extension group.
Transfer -
606 + Group number
(01 ~ 50)
Cancel Delayed Transfer. Transfer -
607 + Group number
(01 ~ 50)
Set up DND for each extension
group.
Transfer -
608 + Group number
(01 ~ 50)
Cancel DND for each extension
group.
Transfer -
611 Use a SLT to listen the General
Message.
Voice Response System (VRS) -
612 + 3 to erase, 5 to
listen or 7 to record
Record, listen to or erase the
General Message.
Voice Response System (VRS) -
616 + 3 to erase, 5 to
listen or 7 to record
Record, listen to or erase a VRS
Message.
Voice Response System (VRS) -
618 Use Night Mode Switch for other
group.
Night Answer
620 Use Common Cancel Service
Code.
Common Cancel -
ISSUE 1.0 SL2100
Features and Specifications Manual 2-3
To Next Page
Loading...
