To program a key, press Speaker key, dial 751 (for 2-digit codes) or 752 (for 3-digit codes), press the key
and enter the code (e.g., 48 for Voice Over).
Use this key... For this feature... When you ... Key Lamp Status Also see Srvc
Code
Note
Code: 31
Operation:
Store: While on
call, Press key +
number to store
Use: Press key +
Speaker key or
line
Erase: Speaker
key + Press key
Memo Dial Store, use or check
a Memo Dial num-
ber.
None -
Code: 33
Operation: Call
ext. and receive
busy + Press key
Off-Hook Signaling Signal a busy ex-
tension.
None 709
Code: 34
Operation: Call
ext + Press key
Barge-In Barge-In on a co-
worker’s conversa-
tion.
None 710
Code: 35
Operation: Call
busy extension or
access busy trunk
+ Press key
Callback / Camp-
On / Trunk Queuing
Leave a Callback
request at a busy
extension, Camping
On to a busy exten-
sion, or Queue for a
busy trunk.
On red when activated 750
Code: 36
Operation: Dial
busy ext + Press
key
+ pswd
(0000) + place
outside call
Department Step
Calling
Step Call through a
Department Group
for an idle member.
None 708
Code: 37
Operation: Call
extension + Press
key
Call Forwarding / Do
Not Disturb Override
Override an exten-
sion Call Forward-
ing or Do Not Dis-
turb.
On red when activated 707
Code: 38
Operation: Leave
message: Call ext
+ Press key OR
Answer message:
Press key
Message Waiting Answer/Leave a
Message Waiting.
None
0
or
0
Code: 39
Operation: Press
key at destination
and source + ext
Room Monitor Activate Room
Monitor.
Fast Flash red at des-
tination, Hold Flash
red at source
-
Code: 41 + sec.
ext.
Operation: Press
key
Secretary Call Call your secretary
(using the buzzer).
On red at source Fast
Flash red at destina-
tion
-
Code: 42 + boss
ext.
Operation: Press
key
As a secretary pick
up a call ringing
your boss’s exten-
sion.
On red when activated -
Code: 43
Operation: TRK
call + Hold + ext +
Press key
Serial Call Place a Serial Call
to a co-worker.
None -
ISSUE 1.0 SL2100
Features and Specifications Manual 2-21
To Next Page
Loading...
