NEC SL2100 - Program 14-07-01; Configuration Sheet: Outgoing Excahnge Line Access

SL2100 GETTING STARTED GUIDE
61
2.10.2 Program 14-07-01
This program allows you give each exchange line the access properties for the TAM number. Each exchange
line (CO1, CO2, CO3, and CO4) have full access (property type 7) for TAM number 1. Each telephone can
access any of the trunks.
2.10.2.1 Default Setting
Each exchange line (CO1, CO2, CO3) has full access (Property type 7) for TAM number 1. Therefore
every telephone can access any of the trunks.
No.
Operation
Display Shows;
1 Log into Programming Mode.
If you have already logged into Programming Mode, skip this
operation.
2
Dial 14 07 01. Enter the TAM Number and press DND key to
Select Trunk number (001-128) and step to the Next option.
3 Enter the Access Property Number (0-7) for each trunk, you can
overwrite the current entry.
0 – No access
1 – Outgoing only
2 – Incoming only
3 – Retrieve held call only
4 – Outgoing and retrieve held call
5 – Incoming and retrieve held call
6 – Incoming and outgoing
7 – Incoming, outgoing and retrieve held call
4
Press Hold key to confirm the entry and step to the next option.
5
When you are done, press Mute key several times to return to
Programming Mode.
6 Press Speaker key to save changes and exit if you are finished.
2.10.3
Configuration sheet: Outgoing Excahnge Line Access
Use following table to record the outgoing exchange line access.
Give each telephone a TAM number.
PRG 15-06-01 TAM Number for each day/night mode
Default=TAM1 for all modes
Telephone
1
2
3
4
5
6
7
8
101
102
103
104
105
106
107
108
There are 128 TAM numbers available.
_________________________
______Program Mode_______
_Base_Service_OP1__OP2__
14-07-01 Access Map1
TRK 001 = 7: Full access |2
← - + →
14-07-01 Access Map1
TRK 001 = 7: Full access |2
← - + →