NEC SL2100 - Program 11-07-01; Configuration Sheet: Department Groups

SL2100 GETTING STARTED GUIDE
66
2.13.5 Program 11-07-01
Give the department group a pilot number. Try to use a number that is easy to remember.
For example use:
Pilot number 401 for group 1
Pilot number 402 for group 2….etc.
2.13.5.1 Default Setting
There are no pilot number assigned.
No.
Operation
Display Shows;
1 Log into Programming Mode.
If you have already logged into Programming Mode, skip this
operation.
2
Dial 11 07 01. For each group, enter the pilot number (3 digits
required). Dial to reach the group and press Hold key to confirm the
entry and step to the next group. If you duplicate a number, you will
see Duplicate Data. The entry will be removed and you can enter a
new number.
3 When you are done, press Mute key several times to return to
Programming Mode.
4 Press Speaker key to save changes and exit if you are finished.
2.13.6 Configuration Sheet: Department Groups
Defaults are shown.
Telephone
number
Department
Group
number
16-02-01
default=1
Priority
number
16-02-01
101 1
102 2
103 3
104 4
105 5
106 6
107 7
108 8
Department
Group
number
1-50
Pilot Number
11-07-01
Ring in
priority/random
16-01-02
default=0 Priority
Try once or
continually
16-01-04
default=0 Once
Ring time before
step on
16-01-09
default=15
seconds
1
2
3
4
There are 50 groups available, only four are listed as this is usually sufficient.
_________________________
______Program Mode_______
_Base_Service_OP1__OP2__
11-07-01 TEL Group1
Ext Grp No. _
← - + →