Figure 9-3 Example Configuration 1 - Static IP Addressing, One LAN
Programming - CPU:
10-12-01 : CPU Network Setup - IP Address (for CPU) 0.0.0.0
10-12-10 : CPU Network Setup - Subnet Mask 255.255.255.0
10-12-03 : CPU Network Setup - Default Gateway 192.168.1.254
10-12-09 : CPUNetwork Setup - VoIPDB IP Address
(This assignment is for CPU-C1 when the VoIPDB daughter board is installed.)
192.168.1.20
Programming - VoIP DSP Resource:
84-26-01 : VoIP Basic Setup - IP Address (Slot # - DSP) 192.168.1.21
Programming - IP Phones:
DHCP Mode Disabled
IP Address 192.168.1.200
Subnet Mask 255.255.255.0
Default Gateway 192.168.1.254
1st Server Address 192.168.1.20
1st Server Port 5080
6.2 Example Configuration 2 - Dynamic IP Addressing, One LAN
This example shows System IP Phones connected to a single LAN (no routers) with dynamic IP
Addresses. The DHCP server could be:
• Customer supplied (e.g., Windows server)
• inDHCP internal DHCP server
In this case, additional programming would be required. Refer to General IP Configuration on
page 4-1.
ISSUE 1.0
SL2100
Networking Manual 9-5
To Next Page
Loading...
