EasyManua.ls Logo

NEC SL2100 - Figure 9-6 8 IPLD Encryption

NEC SL2100
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Source Destination SRTP Comment
8IPLD PSTN S The encryption will be between the IP terminal and the
VoIPDB. Once the voice leaves the SL2100 to the public net-
work it cannot be encrypted.
8IPLD IP Network (SIP) S The encryption will be between the IP terminal and the
VoIPDB. Once the voice leaves the SL2100 to the SIP net-
work it cannot be encrypted.
8IPLD Encryp-
tion On
8IPLD Encryption Off N‘
S = Supported N = Not Supported
PSTN
IP Network
Chassis
STD SIP
Not Encrypted
Encrypted
8IPLD/DT8008IPLD/DT8008IPLD/DT800
SRTP
Figure 9-6 8IPLD Encryption
Conditions
Encryption is not supported on 8IPLD series phones that are connected via NAPT.
If the encryption feature is enabled in terminal programming but not licensed, the terminal displays
“Invalid server” and will not function.
13.4 General IP Configuration
The voice quality of VoIP depends on variables such as available bandwidth, network latency, and
quality of service initiatives (QOS). These variables are controlled by the network and Internet service
providers. Because these variables are not in NEC control, NEC cannot guarantee the performance of
the users IP based voice solution. NEC recommends connecting the VoIP equipment through a local
area network using private IP addresses.
To ensure a network meets the specific requirements for VoIP implementation, an IP ready check and
a site survey must be completed at each site before VoIP implementation.
One way delay must not exceed 100ms.
Round trip delay must not exceed 200ms.
Packet loss must not exceed 1%.
Data switches must be manageable.
Routers must provide QOS.
There must be adequate bandwidth for estimated VoIP traffic. Refer to Section Bandwidth on
page 9-26.
Depending on how QOS policies are built in the network, assignments may be needed in both the
CPU and IP terminal. The NEC SL2100 supports the flagging of packets at layer 2 (VLAN tagging
802.1Q/802.1P) and at layer 3 levels.
SL2100
ISSUE 1.0
9-14
IP Multiline Station (SIP)

Table of Contents

Other manuals for NEC SL2100

Related product manuals