7. Click Save.
Figure 9-16 Save Network Settings
8. After saving settings, click OK to confirm. Telephone reboots and applies the VLAN settings.
Figure 9-17 Save Confirmation Window
13.5.4 Entering VLAN Settings by Phone (Voice Packets Only)
1. Press Hold, Transfer, *, # to enter programming mode.
2. Enter the user name of ADMIN and password of 6633222, then press the OK softkey.
3. Dial 1 for Network Settings.
4. Press 6 on the dial pad for Advanced Settings
5. Press 1 on the dial pad for LAN Port Settings (VLAN for the voice packets only)
6. Press 2 on the dial pad for VLAN Mode
7. Press 1 or 2 to disable/enable the VLAN for the voice packets. Press the OK soft key after the
setting is changed.
8. Press 3 on the dial pad for VLAN ID
9. Enter a valid VLAN ID of 1~4094. Press the OK soft key after the setting is changed.
10. Press 4 on the dial pad for VLAN Priority
11. Enter the VLAN priority of 0~7. Press the OK soft key after the setting is changed.
12. If no more changes are made, press the Exit soft key three times. Then press the Save soft key,
and the phone reboots.
SL2100
ISSUE 1.0
9-20
IP Multiline Station (SIP)
To Next Page
Loading...
