NEC SL2100 - Page 147

2.2.1 VoIPDB (DSP) Basic Setup
Program Number Program Name Description/
Comments
Assigned Data 1 2 3
84-26-01 VoIP Basic Setup – IP
Address
Assign the IP Address for
the DSP resource.
Note: The VoIPDB IP Ad-
dresses must be statical-
ly assigned.
Default:
Slot 1 = 172.16.0.20
X
84-26-02 VoIP Basic Setup – RTP
Port Number
Assign the RTP Port
Number.
0~65534
Default for DSP1 is
10020
X
84-26-03 VoIP Basic Setup –
RTCP Port Number
(RTP Port Number + 1)
Assign the RTCP Port
Number.
0~65534
Default for DSP1 is
10021
X
2.2.2 VoIP ToS Setup
Program
Number
Program Name Description/
Comments
Assigned Data 1 2 3
84-10-01 ToS Setup – ToS Mode Use this field to define
your SIP QoS marking
for ToS or Diffserv.
When Input Data is set to
1, Item No. 07 is invalid.
When Data is set to 2,
Item No. 02 ~ 06 are in-
valid.
0 = Disabled (Invalid)
1 = IP Precedence
2 = Diffserv
Default is 0
X
2.2.3 SIP Peer to Peer
Program
Number
Program Name Description/
Comments
Assigned Data 1 2 3
15-05-50 IP Telephone Terminal Basic
Data Setup – Peer to Peer
Mode
Enable or disable Peer-
to-Peer mode for SIP
phones. When PRG
10-33-05 NAT mode is
set to 1 (Enable), P2P
mode for SIp phones al-
ways set to Off automati-
cally regardless of this
program setting.
0 = No (Disable)
1 = Yes (Enable)
(default is 0)
X
2.2.4 IP Extension Numbering
Program
Number
Program Name Description/
Comments
Assigned Data 1 2 3
11-01-01 System Numbering Refer to the SL2100 Pro-
gramming Manual for all
options and default set-
tings.
1 = 3 Digit; Intercom
Default is 3 Digit; Intercom
X
11-02-01 Extension Numbering Assign up to eight digits
for extension numbering
Dial (Up to eight digits)
Default
Ports 1~84 = 101~184
X
ISSUE 1.0 SL2100
Networking Manual 10-3