Program
Number
Program Name Description/Comments Assigned Data 1 2 3
10-37-01 UPnP Setup – UPnP
Mode
Default Gateway (WAN),
PRG 10-12-07 can be set
automatically when this pro-
gram is set to 1 = Enable.
0 = No (Disable)
1 = Yes (Enable)
default is 0
X
10-58-01 Network Address –
Network Address
If there are other networks
connected to this system
that are not to be routed
through NAPT translations,
then these networks must
be identified in PRG 10-58.
Use this PRG to assign the
individual IP Address (e.g.
192.168.1.100) or assign the
whole network address (e.g.
192.168.1.0).
Assign a valid IP Address or as-
sign a valid Network Address.
default is 0.0.0.0
X
10-58-02 Network Address –
Subnet Mask
If there are other networks
connected to system that
are not to be routed through
NAPT translations, then
these networks must be
identified in PRG 10-58. Use
this PRG to assign the sub-
net mask for the IP Address
entered in PRG 10-58-01.
Assign a valid subnet mask. de-
fault is 0.0.0.0
X
15-05-16 IP Telephone Terminal
Basic Data Setup –
Password
Assign the authentication
password for SIP single line
telephones.
Up to 24 characters
Default not assigned
X
15-05-45 IP Telephone Terminal
Basic Data Setup-
NAT Plug & Play
Per IP Single line telephone,
enable NAT Plug and Play
so that port forwarding is
NOT required in the router
the IP single line telephone
resides behind. Effective on-
ly when PRG 10-46-14 is set
to 1 = Enable.
0 = No (Disable)
1 = Yes (Enable)
default is 1
X
15-05-47 IP Telephone Terminal
Basic Data Setup –
Registration Expire
Timer for NAT
On a per station basis, this
setting defines the SIP reg-
istration expiry timer. If this
value is set to 0, for the ter-
minal, the value in PRG
84-23-01 is applied.
0 = User Timer in Program
84-23-01 60~65535(sec)
default is 180 seconds
X
15-05-48 IP Telephone Terminal
Basic Data Setup –
Subscribe Expire Tim-
er for NAT
On a per station basis, this
setting defines the SIP sub-
scribe expiry timer. If this
value is set to 0, for the ter-
minal, the value in PRG
84-23-02 is applied.
0 = User Timer in Program
84-23-01 60~65535(sec)
default is 180 seconds
X
84-26-01 VoIPDB Basic Setup
– IP Address
Assign the IP Address for
each DSP resource on the
VoIPDB
xxx.xxx.xxx.xxx
Default:
Slot 1 = 172.16.0.20
X
84-26-02 VoIPDB Basic Setup
– RTP Port Number
Assign the RTP Port Num-
ber.
0~65534
Default for DSP1 is 10020
X
84-26-03 VoIPDB Basic Setup
– RTCP Port Number
Assign the RTCP Port Num-
ber.
0~65535
Default for DSP1 is
10020~10083
X
ISSUE 1.0 SL2100
Networking Manual 10-9
To Next Page
Loading...
