Figure 13-5 Local and Centralized Voice Mail
This configuration is not supported, the local voice mail should be removed and only the centralized
voice mail used.
SECTION 4 PROGRAMMING
4.1 Basic Setup
Program
Number
Program Name/Description Assigned Data
10-12-09 VoIPDB IP Address
Assign the IP Address for the VoIPDB.
If a VoIPDB is installed in the system, NEC recommends
setting program 10-12-01 to 0.0.0.0. All connections to
the system will be made through the VoIPDB.
0.0.0.0~126.255.255.254
128.0.0.1~191.255.255.254
192.0.0.1~223.255.255.254
(default =172.16.0.10)
10-12-10 VoIPDB Subnet Mask
Assign the subnet mask for the VoIPDB card.
Refer to the programming manual for all the
possible valid subnet mask entries.
(default =255.255.255.0)
10-12-03 Default Gateway
Assign the SL2100’s default gateway IP address.
0.0.0.0~126.255.255.254
128.0.0.1~191.255.255.254
192.0.0.1~223.255.255.254
(default =0.0.0.0)
84-26-01 VoIP Basic Setup (DSP)
Assign the IP address that is used for Voice Communica-
tions across the network. The IP address assigned here
MUST be within the same network as the IP address as-
signed in PRG 10-12-09.
0.0.0.0~126.255.255.254
128.0.0.1~191.255.255.254
192.0.0.1~223.255.255.254
(default =172.16.0.20)
11-01-01 * System Numbering
Assign the leading digit/digits of the remote SL Net sys-
tems as: (8) Networked System Access.
Example 1: The Remote SL Net system is going to use
extensions 200 ~ 299 then the digit 2 would be assigned
as: (8) Networked System Access.
Example 2: The Remote SL Net system is going to use
extensions 1200 ~ 1299 then the digits 12 would be as-
signed as: (8) Networked System Access.
0 = Not Used
1 = Service Code
2 = Extension Number
3 = Trunk Access Code
4 = Individual Trunk Access Code
5 = Operator Access
6 = F-Route
8 = Networked System Access
9 = Dial Extension Analyze
(Refer to the SL2100 programming manual for
the default values.)
SL2100 ISSUE 1.0
13-20
AspireNet
To Next Page
Loading...
