NEC SL2100 - Page 76

Program/
Item No.
Description/
Selection
Assigned Data Comments
22-02-01 Incoming Call Trunk Setup 0 = Normal
1 = VRS (second dial tone if no VRS
installed)
2 = DISA
3 = DID
4 = DIL
5 = Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID Mode Switching
Default = 0
Define the SIP trunks as type 3 (DID).
In addition to the SIP trunk program-
ming, refer to the Direct Inward Dialing
(DID) feature in the NEC SL2100 Fea-
tures and Specifications Manuals and
the NEC SL2100 Programming Man-
ual for detailed information.
6.2 IP DSP Resource
If any IP Address or NIC settings are changed, the system must be reset for the changes to take affect.
Program/
Item No.
Description/
Selection
Assigned Data Comments
10-03-01 VoIPDB Configuration – Log-
ical Port Number
0 ~ 128 The CPU-C1 automatically assigns
each blade during installation. READ
ONLY
10-03-02 VoIPDB Configuration –
Trunk Type
0 = H.323
1 = SIP
Default = 1
Assign each trunk type for each DSP
Resource.
10-19-01 VoIP DSP Resource Selec-
tion –VoIP DSP Resource
Selection
0 = Commonly used for both IP Exten-
sions and Trunks
1 = Use for IP Extensions
2 = Use for SIP Trunks
5 = Blocked
6 = Common without Unicast Paging
7 = Multicast Paging
8 = Unicast Paging
Default:
Resource 1 = 1
Resources 2~128 = 0
Define the criteria for each DSP re-
source on the VoIP blade.
14-05-01 Trunk Group Trunk Group = 0~50
Priority = 1 ~ 128
Default = Group1 for all trunk ports
and priorities
Default priorities for trunks 1~128 is
1~128.
Assign Trunks to Trunk Groups/
Outbound Priority
22-02-01 Incoming Call Trunk Setup 0 = Normal
1 = VRS (second dial tone if no VRS
installed)
2 = DISA
3 = DID
4 = DIL
5 = Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID Mode Switching
Default = 0
Set the feature type for the trunk you
are programming.
(Second dial tone for option 1 if no
VRS is installed)
84-26-01 VoIP Basic Setup – IP Ad-
dress
XXX.XXX.XXX.XXX Assign the VOIPDB Gateway IP Ad-
dress.
172.16.0.20
84-26-02 VoIP Basic Setup – RTP Port
Number
0 ~ 65534 Default: 10020
84-26-03 VoIP Basic Setup – RTCP
Port Number
(RTP Port Number + 1)
1 ~ 65535 Default: 10021
SL2100 ISSUE 1.0
7-8
SIP Trunking