NEC SL2100 - Page 77

6.3 SIP Caller ID
Program/Item
No.
Description/
Selection
Assigned Data Comments
14-01-24 Basic Trunk Data Setup –
Trunk-to-Trunk Outgoing Caller
ID Through Mode
0 = Disable
1 = Enable
Default = 0
Enable/Disable the Trunk-to-
Trunk Outgoing Caller ID
Through Mode. This option al-
lows Caller ID from the original
outside caller to be displayed
when a trunk is forwarded off
premise. This option can be used
only with PRI and SIP trunks.
21-17-01 IP Trunk (SIP) Calling Party
Number Setup for Trunk
1 ~ 0, *, # (to equal up to 16 digits)
Default not assigned
This program assigns the Caller
Party Number for each IP trunk.
The assigned number is sent to
the central office when the caller
places an outgoing call. If the
Calling Party Number is assigned
by both 21-17 and 21-18/21-19,
the system uses the entry in
21-18/21-19.
21-19-01 IP Trunk (SIP) Calling Party
Number Setup for Extension
1 ~ 0, *, # (to equal up to 16 digits)
Default not assigned
Select SIP Profile 1-6.
Assign the Calling Party Number
for each extension. The assigned
number is sent to the central of-
fice when the caller places an
outgoing call. If the Calling Party
Number is assigned by both Pro-
gram 21-17 and 21-18/21-19, the
system uses the data in Program
21-18/21-19.
6.4 SIP CODEC Trunk
Program/Item
No.
Description/
Selection
Assigned Data Comments
84-13-01 SIP Trunk CODEC Information
Basic Setup – G.711 Audio
Frame Number
1 = 10ms
2 = 20ms
3 = 30ms
4 = 40ms
Default is 2
Select SIP Profile 1-6.
Set the G.711 Audio Frame Num-
ber.
84-13-02 SIP Trunk CODEC Information
Basic Setup – G.711 Voice Ac-
tivity Detection Mode
0 = Disable
1 = Enable
Default is 0
Select SIP Profile 1-6.
Enable/Disable the G.711 VAD
Detection Mode.
84-13-03 SIP Trunk CODEC Information
Basic Setup – G.711 Type
0 = A-law
1 = μ-law
Default is 1
Select SIP Profile 1-6.
Define the G.711 type.
84-13-04 SIP Trunk CODEC Information
Basic Setup - G.711 Jitter Buf-
fer (min)
0 ~ 255ms
Default is 20
Select SIP Profile 1-6.
Set the minimum G.711 Jitter
Buffer.
84-13-05 SIP Trunk CODEC Information
Basic Setup – G.711 Jitter Buf-
fer (average)
0 ~ 255ms
40ms = Default is 40
Select SIP Profile 1-6.
Set the average G.711 Jitter Buf-
fer.
ISSUE 1.0 SL2100
Networking Manual 7-9