ISSUE 4.0 SL2100
INSTALLING WIRELESS DECT TELEPHONES 132
3. Place the AC adapter cord inside the molded channel of the wall mount stand.
Figure 2-128 Placing the AC Adapter Cord Inside the Wall Mount Stand
4. Plug one end of the short telephone cord (locally supplied) in the LINE jack on the base unit. Plug
one end of the SL2100 digital multiline terminal into the PHONE jack. Place the telephone cords
inside the molded channels on the bottom of the wall mount stand.
5. Plug the other end of the short telephone cord into the modular wall jack in the center of the wall
plate.
6. Place the base unit on the posts of the wall plate and push down until it is firmly seated.
Figure 2-129 Placing the Base Unit on the Posts of the Wall Plate
Because of variation in wall plates, this method is not recommended.
To Next Page
Loading...
