ISSUE 4.0 SL2100
INSTALLING WIRELESS DECT TELEPHONES 134
4. Plug one end of the short telephone cord into the LINE jack on the base unit. Then plug one end
of a SL2100 multiline terminal into the PHONE jack. Place the telephone cords inside the molded
channels on the bottom of the wall mount stand.
Figure 2-132 Placing the Telephone Cords Inside the Wall Mount Stand
5. Place the base unit on the posts of the wall screws and push down until it is firmly seated.
Figure 2-133 Attaching the Wall Mount Unit to the Wall
6. Plug the other end of the short telephone cord into a telephone wall jack.
7. Plug the AC adapter into a standard 120 Vac wall outlet. Refer to Figure 2-130 Plugging the AC
Adapter into the AC Wall Outlet.
Do not use an outlet controlled by a wall switch.
6.1.7 Wall Mounting the Charging Unit
The charging unit can be wall mounted as well. Before mounting the charging unit, consider the
following:
• Select a location away from electrical cables, pipes, or other items behind the mounting location that
could cause a hazard when inserting screws into the wall.
• Make sure the wall material can support the weight of the charging unit.
• Use #10 screws with anchoring devices suitable for the wall material where the charging unit will be
placed.
To mount the charging unit:
To Next Page
Loading...
