ISSUE 4.0 SL2100
INSTALLING WIRELESS DECT TELEPHONES 168
4. Place the spare battery (if available) in the back section of the charger; the BATTERY STATUS
LED should turn on. (Pull the battery latch back slightly to fit the battery in the slot.) See
Figure 2-178 Inserting Handset into the Charger.
Figure 2-178 Inserting Handset into the Charger
Charge each battery completely (about 10 hours) before use.
6.5.3.2 Powering on the Handset
To power up the handset, press and hold End until the display flashes once (about 3 seconds). The
handset searches for the base station or multi-cell chain it is registered to and connects to the unit with
the strongest signal.
To Next Page
Loading...
