NEC SL2100 - Page 192

ISSUE 4.0 SL2100
PROGRAMMING MODE 190
1. Turn the power off, insert the Customer Data SD card into the SD Slot on CPU board.
SD slot (J12)
CPU board
SD card with
Customer data
Figure 3-11 Inserting the SD card
2. Turn the power on, enter the Program Mode then PRG90-04.
Program Mode
Base Service OP1 OP2
90-04-01
Data Load YES:1 1
Figure 3-12 PRG90-04 Display (12TXH/24TXH-B1)
3. Dial 1 and press Hold key.
4. When the data loading is completed, the display changes to the next PRG.
Loading System Data
90-05- M’tenance
Slot Control |01
back Select
Figure 3-13 Next PRG Display (12TXH/24TXH-B1)
5. Remove the SD card and exit from the Program Mode.