NEC SL2100 - Section 3 LED INDICATIONS

ISSUE 4.0 SL2100
LED INDICATIONS 204
Section 3 LED INDICATIONS
The LEDs on the CPU indicate the following:
• RUN (D1) = The CPU is operating (Green)
• ALM (D2) = Alarm (Red)
• Refer to Program 90-10: System Alarm Setup for details on assigning alarm LEDs.
Table 4-1 CPU LED Indications provides a list of each LED and associated operation and status
indications.
ST
100 1G ACT
LOADRUN
ETHERNET VOIPDB
EXP1 EXP2
ALM
RUN (D1) LED: Green
CPU board
< Front view >
ALM (D2) LED: Red
Figure 4-18 Location of the LEDs on the CPU Board
The priority order (No.1 ~ 16) is set up to each status and when more than one different status are
occurred, the highest priority LED indication pattern (status) will be indicated.
Table 4-1 CPU LED Indications
Priority
No.
Status
LED Indication
RUN (D1): Green
ALM (D2): Red
1
When system has started Up (only U-boot is execute)
Off
Off
2
Shutting down accept status (going to be powered off)
500ms On / 500ms Off
Off
3
Boot error
On
1s On / 1s Off
4
DSP/FPGA Download Error
Off
100ms On / 100ms Off
5
Security Tip Error
100ms On / 100ms Off
100ms On / 100ms Off
6
Reading Error of System Program Update
1s On / 1s Off
100ms On / 100ms Off
7
Completed the System Program Update
1s On / 1s Off
1s On / 1s Off
8
During System Program Update
(Main Software Ver.
1.05.05 or higher)
100ms On / 100ms Off /
100ms On / 100ms Off /
100ms On / 500ms Off
(Main Software Ver.
1.05.05 or higher)
100ms On / 100ms Off
9
DSP/FPGA downloading
Off
1s On / 1s Off
10
Boot is starting
On
Off
11
IP address lease request
300ms On / 200ms Off /
300ms On / 200ms Off /
300ms On / 700ms Off
Off
12
DHCP Reset request
300ms On / 200ms Off /
300ms On / 200ms Off /
300ms On / 700ms Off
On
13
File accessing (SD Memory card/Flash ROM data is up-
dating)
100ms On / 100ms Off /
100ms On / 100ms Off /
100ms On / 500ms Off
Off
14
Error alarm (Major) occurred
100ms On / 100ms Off
1s On / 1s Off