ISSUE 4.0 SL2100
INSTALLING THE MAIN & EXPANSION CHASSIS 54
Figure 2-24 System Expansion Cabling. (Ferrite Core is attached with the EXIFE- C1.)
Make sure you do not apply undue force and damage the cable when
clamping on ferrite core.
To prevent damage, when the cable is clamping on ferrite core, do not
connect both side of the cable to EXIFB board and EXIFE board. It
applied excessive stress to the RJ61 connectors on both EXIFB board and
EXIFE board.
Figure 2-23 Installing Ferrite Core
Attach one end to each Expansion Chassis EXT connector on the EXIFE board (see
Figure 2-24 System Expansion Cabling). Attach the opposite end to the EXP1, EXP2 connector on
the EXIFB of the Main Chassis.
To Next Page
Loading...
