Item
No.
Item Input Data Description Default Related
Program
40 Calling name dis-
play info via
trunk for stand-
ard SIP
0 = Both name and
number
1 = Name only
2 = Number only
3 = None
Trunk name is the first priority and
abbreviated (SPD) name is second
priority
0
41 Time Zone(hour) 0 ~ 24
(- 12 ~ + 12 hour)
12
43 Video Mode 0 = Disable
1 = Enable
0
44 Using STD-SIP
Display for CPN
0 = Disable
1 = Enable
0
45 NAT plug & play 0 = OFF
1 = ON
Effect this program only when PRG
10-46-14 (for IP Multiline Terminals)
or PRG 10-33-05 (for Standard SIP
Terminal) are set to NAT mode.
Effect this program only when PRG
10-46-14 (for IP Multiline Terminals)
is set to NAT mode.
If you are setting the SIP Terminal
using remote router by turning this
setting ON you don't need to set the
Port Forward on remote router side.
Select sending RTP port number to
remote Router, use from negotiation
result (0) or received RTP packet (1)
1 10-46-14
46 Door Phone
Number
0 = Not door phone
1 ～ 6 = Door phone
number
0
47 Registration Ex-
pire Timer for
NA
T
0 = Disable
60 ~ 65535 (sec)
On a per station basis, this setting
defines the SIP registration expiry
timer. This setting applies to IP Mul-
tiline Terminals or Standard SIP Ter-
minal connected via NAPT. If this
value is set to 0, for a NAPT termi-
nal, the value in PRG 84-23-01 (for
IP Multiline Terminals) or PRG
10-33-01 (for Standard SIP Termi-
nal) are applied.
180 84-23-01
48 Subscriber Ex-
pire Timer for
NAT
0 = Disable
60 ~ 65535 (sec)
On a per station basis, this setting
defines the SIP subscribe expiry
timer. This setting only applies to IP
Multiline Terminals or Standard SIP
Terminal connected via NAPT. If this
value is set to 0, for a NAPT termi-
nal, the value in PRG 84-23-02 (for
IP Multiline Terminals) or PRG
10-33-01 (for Standard SIP Termi-
nal) are applied.
180 84-23-02
49 Receiving SIP IN-
FO
0 = Disable
1 = Allowed any time
2 = Allowed while RTP
is not available
Enables to receive a SIP INFO mes-
sage from a standard SIP phone as
a dial information.
2
50 Peer to Peer
Mode
0 = Off
1 = On
1
51 Transport Proto-
col
0 = UDP
1 = TCP
2 = TLS
This program is the transport proto-
col. (Read only)
0
Conditions
None
SL2100 ISSUE 2.0
2-146 Program 15 : Extension, Basic Setup
Program
15
To Next Page
Loading...
