NEC SL2100 - Selectable Display Messages

Program 20 : System Option Setup
20-16 : Selectable Display Messages
Level:
SA
Description
Use Program 20-16 : Selectable Display Messages to enter the Selectable Display Messages.
There are 20 alphanumeric messages, with up to 24 characters. Use the following chart when
programming messages.
Use this keypad digit ... When you want to ...
1 Enter characters: 1 @ [ ¥ ] ^ _ ` { | } Á À Â Ã Å Æ Ç É Ê ì ó 0
2 Enter characters : A-C, a-c, 2.
3 Enter characters : D-F, d-f, 3.
4 Enter characters :
G-I, g-i, 4.
5 Enter characters : J-L, j-l, 5.
6 Enter characters : M-O, m-o, 6.
7 Enter characters : P-S, p-s, 7.
8 Enter characters : T-V, t-v, 8.
9 Enter characters : W-Z, w-z, 9.
0 Enter characters : 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В
*
Enter characters :
*
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are needed - ex :
TOM). Pressing # again = Space. (In system programming mode, use the right arrow soft
key instead to accept and/or add a space.)
Clear/Back or
DND (2W Digital/IP
Multiline Terminal)
Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
Input Data
Selectable Display Message Number 1 ~ 20
Item No. Item Input Data Default
01 Selectable Display Messages 24 characters Refer below
Default
Number Message
1 IN MEETING UNTIL ## : ##
2 MEETING ROOM - ########
3 COME BACK ## : ##
4 PLEASE CALL ###########
SL2100 ISSUE 2.0
2-208 Program 20 : System Option Setup
Program
20