NEC SL2100 - Page 287

Item
No.
Item Input Data Description Default Related
Program
09 Restriction for
Common Speed
Dials
0 = Does Not Restrict
1 = Following Restric-
tion Check
Use this option to enable/disable
Toll Restriction for Common Speed
Dialing numbers. If enabled, System
Speed Dialing numbers have the
same restrictions as manually dialed
numbers.
0
10 Restriction for
Group Speed Di-
als
0 = Does Not Restrict
1 = Following Restric-
tion Check
Use this option to enable/disable
Toll Restriction for Group Speed Di-
aling numbers. If enabled, Group
Speed Dialing numbers have the
same restrictions as manually dialed
numbers.
0
11 Intercom Call Re-
striction
0 = Disable (ICM call
not restricted.)
1 = Enable (ICM call re-
stricted.)
Determine if incoming intercom calls
are restricted.
0
12 PBX Call Restric-
tion
0 = Disable (PBX/CTX
call not restricted.)
1 = Enable (PBX/CTX
call restricted.)
Use this option to set how the sys-
tem Toll Restricts calls over PBX
trunks. If you enable PBX Toll Re-
striction, the system begins Toll Re-
striction after the PBX access code.
The user cannot dial a PBX exten-
sion. If you disable PBX Toll Restric-
tion, the system only restricts calls
that contain the PBX access code.
The system does not restrict calls to
PBX extensions. Refer to the PBX
compatibility feature. Make sure
Program 21-05-04 (Maximum Num-
ber of Digits Table Assignment) al-
lows for PBX Toll Call Dialing (nor-
mally 12 digits).
Class 1 ~ 6 = 0
Class 7 = 1
Class 8 ~ 15 = 0
13 Restriction of Tie
Line Calls
0 = Disable (No)
1 = Enable (Yes)
It chooses whether the toll restric-
tion of the dial set up by 34-08 is en-
abled or disabled.
0
34-08
Conditions
None
Feature Cross Reference
None
ISSUE 2.0 SL2100
Programming Manual 2-263
Program
21