NEC SL2100 - DID Basic Data Setup

Program 22 : Incoming Call Setup
22-09 : DID Basic Data Setup
Level:
IN
Description
Use Program 22-09 : DID Basic Data Setup to define the basic setting of Dial-In incoming calls for
each trunk group.
Input Data
Trunk Group Number 1 ~ 50
Item
No.
Item Input Data Description Default
01 Dial-In Receive digit 1 ~ 8 Enter the number of digits the table ex-
pects to receive from the Telco. Use this
program to make the system compatible
with 3- and 4-digit DID service. If ISDN
trunks, we analyze the last digits that are
set here. If it is T
-1 or analog DID, it ana-
lyzes the first digits that are assigned here.
4
02 Received Vacant
Number Operation
0 = Disconnect (call de-
nied)
1 = Transfer (call routed
to PRG 22-12)
If the system receives a DID that is not
routed this program sets what the system
does with the call.
If the setting data is a (0), Disconnect, the
system will deny the call.
If the setting data is a (1), Transfer, the call
will be routed to the ring group specified in
PRG 22-12-01.
0
03 Sub-Addressing
Mode
0 = Extension # Specify
(Intercom)
1 = DID Conversion Ta-
ble
0
04 DID Receiving Mode
for ISDN
0 = Enbloc Receiving
1 = Overlap Receiving
0
05 Local Code Digits 0 ~ 15 (0 = No Local
Code)
(Only Overlap Receiving Mode) 0
06 Local Code Dial (maximum 16 digits) (Only Overlap Receiving Mode) No Setting
07 Pilot Code Dial (1 digit : 0 ~ 9) (Only Overlap Receiving Mode) No Setting
08 T302 Time-out Opera-
tion
0 = Disconnect (Cut)
1 = Transfer (Refer to
Program 22-12 : DID In-
tercept Ring Group.)
(Only Overlap Receiving Mode) 0
Conditions
None
SL2100 ISSUE 2.0
2-294 Program 22 : Incoming Call Setup
Program
22