NEC SL2100 - 4.5 Hold; Transferring Calls; 4.5.1 Holding a Call; Retrieving a Held Call

Item No. Item Input Data Description Default
02 Logical Port Number [0 : No Setting] = 0
[1 : T-Point] = 1 ~ 128
[2 : S-Point] = 1 ~ 128
[3 ~ 5] = Not Used
[6 : S-Point (Leased Line)] = 1 ~ 128
The starting port
number of a BRI line
is displayed. Two
logic ports ar
e auto-
matically assigned to
a BRI line.
0
03 Connection Type 0 = Point-to-Multipoint
1 = Point-to-Point
0
04 Layer 3 Timer Type 1 ~ 5
Each timer value of
Layer 3 is set up for
every type using Pro-
gram 81-06 (T
-Bus).
1
05 Calling Party Number 0 = No
1 = Yes
Based on this setting, the
system includes a Pre-
sentation Allowed (1) or
Presentation Restricted
(0) in the Setup message
to allow or deny the Call-
ing Party Number. Pro-
gram 15-01-04 must also
be set to 1 if this option is
enabled.
1
06 Connection Bus Mode 0 = Extended passive bus
1 = Short passive bus
0
07 S-point DDI digits 0 ~ 4 0
08 Dial Sending Mode 0 = Enblock Sending
1 = Overlap Sending
ISDN Protocol definition
1
09 Dial Information Element 0 = Keypad Facility
1 = Called Party Number
ISDN Protocol definition
[Only when Dial Sending
Mode (10-03-08) is set for
1 (Overlap Sending]
1
10 Master/Slave System 0 = Slave System
1 = Master System
If set to 0, system is
synchronized to network
clock. If set to 1, system
is not synchronized to the
network clock.
0
14 Service Protocol for S-point 0 = Keypad facility
1 = Specified Protocol
0
15 Call Busy Mode for S-point 0 = Alerting
1 = Disconnect
0
17 ISDN Line Ringback Tone 0 = Disable
1 = Enable
System can provide ring-
back tone, if set to 1 : En-
able.
0
18 Type of Number 0 = Unknown
1 = International number
2 = National number
3 = Network specific number
4 = Subscriber number
5 = Speed Dial number
ISDN Protocol definition 0
19 Numbering Plan Identifica-
tion
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering plan
5 = Private numbering plan
ISDN Protocol definition
0
25 Layer 1 Supervision 0 = Disable
1 = Enable
0
26 Screening Indicator
(V1.5 added)
0 = user-provided (not screened)
1 = user-provided (verified and
passed)
2 = user-provided (verified and failed)
Calling Party Number in-
formation element
Screening indicator (octet
3a)
0
ISSUE 2.0 SL2100
Programming Manual 2-11
Program
10