NEC SL2100 - Program 26: ARS Service & Least Cost Routing; Automatic Route Selection (ARS;F-Route) Service

Program 26 : ARS Service & Least Cost
Routing
26-01 : Automatic Route Selection (ARS/F-Route) Service
Level:
IN
Description
Use Program 26-01 : Automatic Route Selection Service (ARS/F-Route) to define the system
options for Automatic Route Selection (ARS/F-Route).
Input Data
Item
No.
Item Input Data Description Default Related
Program
01 ARS Service 0 = Disabled (ARS
service is OFF.)
1 = Enabled (ARS serv-
ice is ON.)
Enable or disable ARS. 0
26-02
26-03
26-04
26-05
02 Network Outgo-
ing Inter-Digit
ARS Time
0 ~ 64800 seconds With Networking, this time replaces
20-03-04 when determining if all
network protocol digits have been
received. If ARS is enabled at Site
B, this time can be programmed for
5 (500 ms) at Site A. If ARS is disa-
bled and Site B is using F-Route for
outbound dialing, this time should
be programmed for 30 (three sec-
onds) at Site A.
30 20-03-04
03 ARS Misdialed
Number Han-
dling
0 = Route to Trunk
Group 1
1 = Play Warning Tone
to Dialer
If a user dials a number not pro-
grammed in ARS, this option deter-
mines if the system should route
over Trunk Group 1 or play error
tone.
0 21-02
26-02
06 Class of Service
Match Access
0 = Disabled (ARS
service is OFF.)
1 = Enabled (ARS serv-
ice is ON.)
This enables/disables the ARS class
of service settings.
0 26-02
07 F-Route Access
COS Reference
0 = F-Route
1 = ARS
0 26-02
44-05
Conditions
None
Feature Cross Reference
• Automatic Route Selection (ARS/F-Route)
ISSUE 2.0 SL2100
Programming Manual 2-337
Program
26