Program 26 : ARS Service & Least Cost
Routing
26-03 : ARS Dial Treatments
Level:
IN
Description
Use Program 26-03 : ARS Dial Treatments to assign the 15 Dial T
reatments for automatic ARS
dialing translation. Assign Dial Treatments to Service Numbers (Trunk Groups) in Program 26-02. The
ARS Dial Treatment options are:
• Dnn - Outdial the NN number of digits or execute the code that follows. For example, D041234 out-
dials 1234. Valid entries are 0-9, #,
, Wnn (wait nn seconds) and P (pause). Each digit code counts
as a digit. So, for example, if a "P" was added for a pause, the entry would look like:
D05P1234. This Dial Treat can only be added from telephone programming.
• Wnn
- Wait nn Seconds.
• P - Pause in Analogue Trunk.
• R - Redial the initially dialed number, including any modifications.
• X - When ARS is enabled, X must be entered in the Dial Treatment in order for the system to out-put
the extension number of the call's originator to the black box for the E911 feature.
• An - Insert a Transit Network ID for alternate access in the SETUP message. `n' refers to
PRG26-11.
• E - End of the Dial Treatment. All Dial Treatments must end with the E code.
Applied to US only
• 3 - Delete the NPA if dialed as part of the initial call.
• 2 - Delete the leading if dialed as part of the initial call.
• 1 - Add a leading 1 if not dialed as part of the initial call.
• Inpa - Insert the NPA specified by npa.
Input Data
Dial Treatment Table Number 1 ~ 15
Item
No.
Item Input Data Default
01 Treatment Code Maximum 36 characters No Setting
Conditions
None
Feature Cross Reference
• Automatic Route Selection (ARS/F-Route)
ISSUE 2.0 SL2100
Programming Manual 2-339
Program
26
To Next Page
Loading...
