Program 90 : Maintenance Program
90-68 : Side Tone Auto Setup
Level:
IN
Description
This program is available only via telephone programming and not through PC Programming.
Use Program 90-68 : Side Tone Auto Setup to setup the volume level of Side T
one for each Analog
Trunk Port.
This program will change the setting of "PRG 81-07 CODEC Filter Setup for analog Trunk Port" If the
Analog Port is in used or if it is other than a Analog Trunk Port then it will give out the error message.
Input Data
Item
No.
Item Input Data Description Default Related
Program
01 Adjustment Start Trunk Port Number
1 ~ 128
This will start the Adjustment of Side
Tone for each Analog T
runk Port. If
it is successful it will change the
PRG 81-07. If it is successful it will
ask to change it for all Analog Trunk
Port.. If you select to change the
Setting All Analog Trunk Port it will
change all the Port in 81-07.
No Setting 81-07-01
81-17-01
21-01-05
21-01-06
14-01-07
21-06-06
21-05-07
02 1 digit data Dial (1 dight) This setting will ask to use the digit
after Line is retrieved.
0 -
Conditions
• All phones and trunks must be idle in order to perform the Side Tone Auto Setup test. If any phone
or trunk is in use, "Busy" will be displayed when trying to run 90-68-01.
•
All phones will become unresponsive while the Side Tone Auto Setup tests are running.
Feature Cross Reference
None
SL2100 ISSUE 2.0
2-634 Program 90 : Maintenance Program
Program
90
To Next Page
Loading...
