Configure the SL2100
Quick Install Guide – SL2100 with ISDN PRI Trunks rev 1.1 31
Make Additional Changes with PCPro
Note – Only required if the configuration you selected via the Initial Setup Wizard requires fine tuning.
Connect and Download the SL2100 configuration, then click Chassis View within the
Home TAB.
Click on any port (trunk, extension or audio) within the Chassis screen to view the properties within the
Properties pane and make changes to the system configuration.
When done, click Upload to send the changes to the SL2100 system.
Click Disconnect to finish.
Note – Not all options are available within the Properties pane when you are offline (not connected to the
SL2100), configuration within this guide is done online so you should always:
1. Connect to the SL2100
2. Download the system configuration (always download before you make any changes)
3. Then begin your configuration changes (remember to save the PCPro file to your PC)
4. Upload your changes and Disconnect
To Next Page
Loading...
