NEC SL2100 - 4.3.5 Cancel Message Waiting; 4.4 Answering Calls; 4.4.1 Answering an Outside Call

Configure the SL2100
Quick Install Guide – SL2100 with ISDN PRI Trunks rev 1.1 33
DDI Routing
Use the DDI pane to show a summary of the DDI’s that were setup by the Initial Setup wizard.
Select any of the DDI’s Day/Night mode routing to configure within the Properties pane.
 Target 1 = Extension number (leave blank if not required and next target will be used)
 Transfer Operation Mode = step on from Target 1 to Targets 2 or 3 (None, Busy, No-Answer or Busy &
No-Answer)
 Target 2 & 3 = Incoming Ring Group number 1-25, VRS Auto Attendant 501-504
Note - other options are available but not included within this guide.
The no answer step on timers are in seconds and apply to all DDI’s.
Tip – Decide on the Night Modes and the quantity of Incoming Ring Groups required before you begin editing
within PCPro, then build your Incoming Ring Group members and finally assign the groups to the DDI’s for each
mode.
Tip – Setup your Automatic Night Mode schedule (if required) before you configure the Incoming Call Routing.
Tip – Create your Incoming Ring Groups first (within the Incoming Ring Group pane) before assigning the Group
number as the target for a DDI.
DDI routing
Received DDI
numbers
Day/Night modes
DDI name
Targets 1, 2 & 3
Click button to open
Easy Edit screen for
DDI’s
Select optional level
to display DDI timers
T1 -> T2 or T3
T2 -> T3